Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.
Changing door locks do it yourself.
Install your new lockset making sure that the keyed section is on the outside.
In apartment complexes this is now the most common way of changing locks on a door.
Put the two pieces together and then screw in the door piece.
Installing the new lock is an.
Remove the old lock.
Changing locks on doors.
How to change a lock step 1.
You will want to find one that is keyed on only.
Purchase a new lock.
Step 1 purchase a new lock.
Rekeying involves realigning the pins and springs in the inner workings of the lock in order to match the lock.
Once the new pins are in reverse the steps to reassemble the lock.
Changing the lock yourself examine the latch of the door to determine what brand of lock it is.
Step 2 remove the screws from two halves of lock.
Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to.
Then remove each side s door knob by pulling them away from the door.
Purchase the same lock from a local hardware store.
Step 2 remove the old lock.
Begin by removing the screws from the door knob on the interior side of your door.
Step 1 prop the door open.
Step 3 install the new lock.
In some cases door latch plate mortises might need to be cut or enlarged.
As stated above you need access to both sides of the door at the same time when changing locks.
You may also need to use a wire tool or a paper clip.
Remove the old deadbolt.
Step 4 insert new tongue plate.
Remove the screws from the old lock on the inside of the door.
Everything should work without having to put new holes unless you change the style of your door knob.
Chisel out any uneven recesses in the latch so that your new latch will fit perfectly.
Now put the door handle together in the opposite way that you took it apart.
This allows you to pull the door.
Replacing the lock on a front door.
Open the door and.
Go to the store and purchase a new lock.
Measure the back set of the door by measuring from the door latch to the middle of the door knob.
Slide the outside parts of the.
Remove the two visible bolts in the turn assembly plate and then remove the turn plate.
Step 3 remove screws from tongue plate.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
Then screw in the new door knob piece and tighten it with your screwdriver.
